Data Translation MACH Series, Руководство по началу работы

Страница: 49 / 62

Installing and Configuring the Device Driver
41
5
5
5
5
5
5
5
5
5
Installing and Configuring the Device
Driver in Windows XP
Perform the following steps to install and configure the device driver
in Windows XP:
Note: This procedure assumes that no other MACH I Series drivers
(DT3152, DT3152-LS, DT3153, DT3154, DT3155, or DT3157) are
installed in your system. If you previously installed a MACH I Series
driver, refer to the Data Translation knowledgebase at
www.datx.com for information on removing the existing inf file
before performing this procedure.
1. If you have not already done so, power up your computer and
any attached peripherals.
Note: On power-up, the PCI bus takes one available interrupt
from system resources for the DT3154 board. If any devices are
using this interrupt, problems may arise. Verify that no other
devices in your system are using the same interrupt that the
DT3154 board is using and ensure that PCI interrupts are enabled
in your system BIOS.
2. Start Windows XP.
The Found New Hardware dialog box appears.
3. Click Next .
4. Click Install from a list or specific location (advanced) , then
click Next.
5. Insert the Imaging OMNI CD into the CD-ROM drive.
6. Click Search for the best driver in the these locations .