Data Translation MACH Series, Руководство по началу работы

Страница: 50 / 62

Chapter 5
42
7. Click Include this location in the search .
8. Click Browse , browse to x:\DRIVERS\DT3154\WIN2K (where
x is the letter of your CD-ROM drive) , and click Next .
A Hardware Installation dialog box appears.
9. Click Continue Anyway .
The DT3154 Configuration dialog appears.
10. Click Add New to add a DT3154 board to the configuration.
The DT3154 Installation dialog box appears for the new board.
11. Enter any unique name (or alias) for the DT3154 board, then click
Add . Only one alias per installed board is allowed.
The DT3154 Configuration dialog box appears.
12. Select Enable Board to activate the board. If you want to retain
the settings but disable the board (and therefore not use the
memory), remove the checkmark next to Enable Board.
13. Select the Video Format as either 50 Hz or 60 Hz.
14. For Desired Memory Size , select the amount of contiguous
memory (in MB) that you want to allocate in your system to hold
the acquired frames. A 60 Hz, 640-by-480 image requires 1.2 MB
per frame; a 50 Hz, 768-by-576 image requires 1.7 MB per frame.
The actual amount of memory that the device driver can allocate
depends on your system resources. It is recommended that you
select only as much memory as you need to leave memory for
other devices. Once you enter the desired memory size, the
device driver allocates as much memory as possible to match the
value you entered; the actual memory size allocated is shown in
the
Actual Memory Size text box when you restart your system.
15. For Signal Type , click RGB for one RGB input, Triple MONO for
three monochrome inputs, or Dual MONO for two monochrome
inputs.
16. Click Done .
The DT3154 Configuration dialog box is redisplayed; you can see the
name of the board you just added.