Data Translation MACH Series, Руководство по началу работы

Страница: 43 / 62

Installing and Configuring the Device Driver
35
5
5
5
5
5
5
5
5
5
Installing and Configuring the Device
Driver in Windows Me
Perform the following steps to install and configure the device driver
under Windows Me:
1. If you have not already done so, power up your computer and
any attached peripherals.
Note: On power-up, the PCI bus takes one available interrupt
from system resources for the DT3154 board. If any devices are
using this interrupt, problems may arise. Verify that no other
devices in your system are using the same interrupt that the
DT3154 board is using and ensure that PCI interrupts are enabled
in your system BIOS.
2. Start Windows Me.
The New Hardware Found dialog box appears. The board is recognized
as the DT3154, then a dialog box appears prompting you to restart your
system.
Note: In some machines, the DT3154 may not be detected
automatically when you start Windows Me. If this should occur,
remove any other imaging drivers by using the
MACHUNLD.EXE utility (accessed from Start\Programs\Data
Translation, Inc), then perform the following procedure:
a. From the Control Panel, double-click Multimedia .
b. Double-click System .
c. Click Device Manager .
d. Click Refresh .
The New Hardware Found wizard appears.
e. Click Next .
f. Click Search for best driver for your device , then click Next .