Data Translation MACH Series, Руководство по началу работы

Страница: 44 / 62

Chapter 5
36
g. Browse to the Drivers\DT3154\Win98 directory on the
Imaging OMNI CD, then click OK .
h. Click Next .
i. Click Next .
j. Click Finish .
A dialog box appears prompting you to restart your system.
3. Remove the CD-ROM from the CD-ROM drive, then click Yes .
After the system restarts, a dialog box appears prompting you to
configure the driver.
4. Click OK , then click OK .
5. Click Add New to add a DT3154 board.
The DT3154 Installation dialog box appears for the new board.
6. Enter a board name (alias), which can be any name you choose,
then click
Add . The board name is used by supported software,
such as DT-Acquire and the Frame Grabber SDK. Only one name
(alias) per installed board is allowed.
The DT3154 Configuration dialog box appears.
7. Select Enable Board to activate the board. If you want to retain
the settings but disable the board (and therefore not use the
memory), remove the checkmark next to Enable Board.
8. For Video Format , indicate the video format of your video input
source: 50 or 60 Hz.
9. For Signal Type , click RGB for one RGB input, Triple MONO for
three monochrome inputs, or Dual MONO for two monochrome
inputs.
10. For Desired Memory Size , select the amount of contiguous
memory (in MB) that you want to allocate in your system to hold
the acquired frames. A 60 Hz, 640-by-480 image requires 1.2 MB
per frame; a 50 Hz, 768-by-576 image requires 1.7 MB per frame.
The actual amount of memory that the device driver can allocate
depends on your system resources. It is recommended that you
select only as much memory as you need to leave memory for