DAPAudio DLM-26, Руководство по эксплуатации продукта

Страница: 23 / 33

21
Input-adjustments
Input Mode
Press the jog-wheel. In the upper area, the display shows the actual mode (Input / Output). Below, the
parameter with the corresponding value is displayed.
By pressing the jog-wheel repeatedly, you can select between IN A, IN B and IN SUM A+B.
Input Delay
By turning the jog-wheel or pressing the / - buttons ( 5+6 ), you can adjust the desired input delay.
You can set the delay from 0-0.630 ms in 21 s steps.
Input Equalizer
Assignable equalizer
With the DLM-26, you can assign individual equalizers for every channel (IN A, IN B, OUT 1-6). The number
of assignable equalizers depends on the available system memory. If the display shows „No more filters“
you can clear system memory by deleting other programs or equalizers on other channels.
The equalizer types are Hi and Lo shelving filters with 6 or 12 dB per octave or full parametric Bell filters.
The display shows LO6, LO12, Bell, HI6, HI12. The control area is ±15 dB in 0.2 dB steps. The bandwidth
reaches from 0.05 to 3 octaves, adjustable in 0.05 steps (only Bell). The frequency range is from 15 Hz to
20 kHz.
Procedure:
By pressing the PREV-button ( 8 ), you enter the Input EQ menu (for Input A, B) and can adjust the width
(Wd), boost and Gain (+/ -), frequency (Fq) and EQ-type (LO12, LO6, Bell, HI6, HI12) with the PREV- or
NEXT-buttons (
8+9 ) and adjust the individual values with the jog-wheel or the / - buttons ( 5+6 ).
The first equalizer of a channel is preset to Bell, 1 kHz, 0 dB and 0.3 width. Adjust the equalizer to your
requirements. Only after you have changed a value of this equalizer, it will be possible to adjust a second
equalizer for this channel (PREV-button) (
8 ).
In order to add the EQ to Input A+B, first adjust the settings in the individual input (A, B). The settings will
then be added to Input A+B.
Delete an equalizer
You can delete an equalizer you do not need, by adjusting the value for boost and cut to 0 dB. The free filter
can be used for another channel.
If you want to delete an equalizer from an input with Stereo-Link, it may be necessary to cancel the stereo
link first.