DAPAudio DLM-26, Руководство по эксплуатации продукта

Страница: 17 / 33

15
Configuration
Selection of the operation mode (Config)
The DLM-26 can be adjusted in the following operation-modes: Mono
2 Channel 3 Way
3 Channel 2 Way
Note: if you change the operation-mode, all routings and links will be changed, too. Always select the
operation-mode first. Afterwards, you can adjust the output adjustments, routings, delay-links and
output designations.
Select the desired operation-mode in the setup-menu Config and confirm by pressing the SAVE/ENTER-
button (
7 ).
Mono -mode
In the Mono mode, input channel A is routed to all outputs 1-6.
• All crossover frequencies are switched off, i.e. Full Range-signal at all outputs.
• All delay links are switched off.
• Stereo Link is not available.
• The outputs are named Band 1-Band 6.
Operation-mode 2-way
In the operation-mode 2-way, input channel A is routed to outputs 1 and 4. Input channel B is routed to
outputs 5 and 6. Outputs 2 and 5 receive a sum signal of inputs A&B. All delay links are switched off. Stereo
Link is switched on. The outputs are named Low and High.
When using a derived center cluster feed such as in LCR (Left, Center, Right) installation, the configuration
can be changed to a 3 channel 2 way configuration, where the center channel is a sum of A and B.
• Outputs 1 and 4 are routed from Input A.
• Outputs 3 and 6 are routed from Input B,
• Outputs 2 and 5 will be routed from Input sum A+B.
• All delay linking defaults to off.
• Stereo Link will be switched on.
• Band Names will be set to 'Low' and' High'.