31
Maintenance and care
: Trouble shooting
en
Trouble shooting
This section shows how to acknowledge and understand possible operation errors.
For a proper error search, Dantherm strongly recommends to have a remote control con-
nected and operative with the unit.
Any possible error will be displayed on:
Device
Signal
Unit
Acoustic buzzer signal from the main PCB. Connect a remote or PC
Tool, in order to get the specific error shown.
LED for filter reset
Handheld remote
control
Acoustic buzzer signal as well as displaying a specific error code.
Wired remote con-
trol (HCP 10/11)
Acoustic buzzer signal and flashing LED.
The number of flashes corresponds to an error code, followed by a 5
second break.
See Error list.
PC Tool
Displaying error number, as well as being able to log specific opera-
tions, over a longer time span.
Smartphone APP
Displaying a specific error code.
Errors shown on the display, is a three digit information. F. ex. “E12” means error number 12.
How to read the error list:
Column Desciption
Code
Meaning
A
Number of flashes in display (Wired control)
-
-
B
LED in foil panel
Y
Yellow LED flashing
R
Red LED flashing
C
Sound
0
No beep
1
One beep/hour
2
One beep/sec
After completion of any inspection or repair, due to possible errors, the unit can be reset by
disconnecting / re-connect the 230V AC power. This will reset the controller, and the unit will
start normal operation, and also restart a new search for possible errors.
This could last up to 15 minutes.
Introduction
Error signalling
Error list
Resetting errors
