Dantherm CC 3000, Руководство по обслуживанию

Страница: 34 / 40

34
Service : Firmware, datalog & communication
The CC3000 Controller has a standard RJ45 connection for network connection, an SNMP
interface and modbus over TCP/IP included.
•
Network settings are done via WEB GUI, TTL link, SD card or Modbus configuration setup.
The SNMP interface makes it possible to add the CC3000 controller to your existing network
and enables you to interact (both “get/set” and “trap” functions) with the CC3000 controller
from your NOC (Network Operation Center) .
Firmware upgrade and file transfer between CC3000 and NOC can be done using TFTP.
See this table:
Options for use TFTP-examples
• Download configuration file.* Tftp -i [ip address] get cc_cfg.txt
• Upload configuration file* Tftp -i [ip address] put cc_cfg.txt
• Download log file. (from SD card)* Tftp -i [ip address] get stat_log.txt
• Upload firmware * ** Tftp -i [ip address] put cc3k_app.bin
*(from CC3000 controller to NOC)
** Note: After upload of new firmware a
controller reset must be initiated by either
power cycling the controller or by activating
reset in WEB GUI.
Specifications:
•
Supporting up to 3 different trap managers.
• MIB file is available. RFC 1213
• SNMP uses Version 1 protocol.
The CC3000 controller has a WEB interface (GUI) implemented, for easy access via IP address.
It can advantageously be used for monitoring the system. See more on page 32.
Ethernet
To check IP address of controller:
• Use WEB GUI and go to network settings.
WEB GUI