Dantherm CC 3000, Руководство по обслуживанию

Страница: 29 / 40

29
Operation : Sub-menu: System setting level
When night mode is enabled and starts, the controller can change to another
cooling mode, limit max fan speed or do set point offset.
NB: If this function is used, current date and time must be set.
List of settings:
•
Disable/enable (Night mode function)
• Start time. (Defines at which time night mode function is active)
• End time. (Defines at which time night mode function is in-active)
• Current time. (clock setting)
• Current date. (Calendar setting)
• Max speed %. (Defines max.fan speed in % during night mode)
• Set point offset. (Cooling set point offset during night mode)
• Free cooling. (Only free cooling available)
• Standard. (Free cooling and A/C available)
• Energy save. (Free cooling and A/C available)
• Air-conditioning. (Only A/C available)
All alarms can be configured to any of the 10 hardware alarm outputs.
See more in section “Alarm configuration” on page 29.
Product configuration is used to setup controller for the right product.
When SD card is inserted and controller is started up for the first time the
controller will automatically open the product configuration menu. Choose the
right product for the application.
Default language is set to English.
Use this menu item to change to another language.
Change to local language:
• Insert SD card which contains different language packs.
• Choose and confirm desired language from list.
• Language update will take approximately 3 minutes. The controller is inactive and shows
black screen during update.
• Do not disconnect power during update.
Change back to English language:
•
Go to “Other settings” and change back to default language (English). (See page 30)
Adjust and change following settings for Ethernet connection and SNMP trap
management.
List of settings:
•
Static/DHCP. (static or dynamic IP address)
• IP address. (Read/write Controller IP address)
• Subnet mask.
• Gateway IP
• Trap manager 1 IP. (IP address of alarm trap manager 1)
• Trap manager 2 IP. (IP address of alarm trap manager 2)
Night mode
settings
Alarm
configuration
Product
configuration
Language settings
Network settings
en