05721-1098 <90-00050>
P
AGE
15
S
TEP
5A - B11-46020-00 MAP
Refer to Figures 8 and 9 for MAP switch locations. Set switch
settings of 46020-40 per following table:
After switches are set, the MAP will require configuration.
Connect a computer to C1 of the 46090 in slot 2 of shelf D, or to
C7 of shelf C. Use the A22-46508 T/Shell practice for instruc-
tions. Master port is set for 1200 baud. Printer port is set for
1200 baud.
S
TEP
5B - B11-46020-00 MAP
Interpoll Delay is a feature of the 46020-40 Multiple Alarm
Processor (MAP). Refer to the 46020-40 Installation and Opera-
tion Manual,
Printer Syntax
section. This command is used to
configure the MAP to interrogate the Multi- Alarm Transmitters
(MATs) through a large number of LSOs.
Using the MAP's printer port, set the IPD value to 128 (500ms).
The command is
IPD 128
. This allows enough time for the MAP
to poll a MAT and to receive that MATs response before polling
the next MAT. Refer to the 46020-40 Manual,
Printer Syntax
section for more details on the use of this command.
INSTALLATION
Shelf C
Slot 12
B11-46020-40 MAP SWITCH SETTINGS AT SERVICE NODE
SWITCHES SHOWN ARE ON (DOWN)
S1
All ON
S2
All ON
S3
1,2,3,5,6,7
S7
All OFF
S6
3,4,5,7,8
S5
All OFF
S4
1,2,3,5,6,7
Master Port = 1200 baud, DCP/F protocol. Printer Port = 1200 baud, Printer
protocol. Both ports = 1 stop bit, 8 word length, no parity.
N
OTE
:
Level of alarms for MAT 16,
point 3 must be A, point 6 must
be B, and point 9 must be C.
All other points must be D.
NOTE UPDATED
