![background image](http://html1.mh-extra.com/html/dankoff-solar-products/suncentric-p/suncentric-p_instruction-manual_3413455003.webp)
1 WARNINGS
Failure to follow these instructions will void the warranty.
REFER TO THE SPECK PUMP OWNER’S MANUAL ENCLOSED, FOR SAFETY
WARNINGS AND ADDITIONAL INFORMATION
The installer is required to reset the “Maximum RPM” setting in the controller to position 2,
illustrated in Section 4.6.
Open circuit (no-load) voltage above 100V will destroy the controller. This may occur if the
wrong PV modules (solar panels) are used, or if the solar array is incorrectly wired. Measure
the array voltage before connecting to the controller. A “48V” (nominal) array should produce
an open circuit voltage around 75-90V under any daylight conditions. (See Solar Array Wiring,
Section 4.3)
Do not attempt to run the ETAPUMP Motor without the ETAPUMP controller.
Do not attempt to use ETAPUMP controller for any purpose other than ETAPUMP.
To be installed, connected and serviced by qualified personnel only. Ensure all power sources
are disconnected when making connections to this unit. Follow all appropriate electrical
codes. There are no user serviceable parts inside the motor or the controller.
Install proper system grounding for safety and lightning protection (See Section 4.2)
Do not touch the controller input or pump wires together to test for a spark.
Do not run the pump dry. Fill it at least half-way with water for testing.
Test the direction of motor rotation before installing the pump (clockwise looking at back of
motor). If direction is reversed, exchange the connection of any two of the three power wires
to the pump. (See Section 4.7)
When pump is stopped by a shadow or by action of float switch, it will restart after a 30–90
seconds.
SWIMMING POOL APPLICATIONS normally do not use a low-water probe or float switch.
Their terminals must be bypassed in the junction box. (See section 4.5)
Installation should be in accordance with local regulations and accepted codes of good practice.
This manual is the property of the pump owner.
Please give it to the owner or maintenance personnel when you are finished!
Request copies from your
SunCentric
supplier, or download from www.dankoffsolar.com
Copyright © 2003 by BERNT LORENTZ KG and DANKOFF SOLAR PRODUCTS, INC. All rights reserved
ETAPUMP
is a registered trademark of BERNT LORENTZ KG
SUNCENTRIC P™ is a trademark of DANKOFF SOLAR PRODUCTS, INC.
Version 1.4
September, 2003
!
!
!
!
!
!
!
!
Содержание SunCentric P
Страница 29: ...8 5 Exploded View of Pump...