Safety configuration
If enabled, a safety mechanism can be used to not allow specific features in the PLUS+1
®
Service Tool
(specifically write parameters, update firmware) when the global safety mechanism state is inactive. The
global safety mechanism state is determined by comparing data from specified CAN message to a given
value using the configurable logic mode (OR/AND).
Enable
•
Not checked: Full access of read and write to the PLUS+1
®
application
•
Checked: Limited access to the PLUS+1
®
application, only read of data is allowed
See all Safety variables in order to define the global safety mechanism.
CAN ID
The global safety mechanism CAN identifier can be 11-bit or 29-bit. The type codes are:
•
Bit 29 = 0: 11-bit type
•
Bit 29 = 1: 29-bit type
•
Bits 0 to 28: CAN identifier
Timeout (ms)
The global safety mechanism Timeout configures the CAN message sent by the control system cyclically
on CAN bus. After the timeout time, if the CAN message configured is not received by the WS device, the
global safety mechanism is disabled. If this value is set to zero, the timeout control is switched off.
It is possible to change the global safety mechanism state by using a single message transmission.
Data type
The following types of information are possible to configure for the global safety mechanism state, by
default the U8 is selected.
User Manual
WS103 Remote Solution
WS Wireless configurator
©
Danfoss | July 2016
AN00000339en-US0101 | 31
