The WS Remote Solutions is a family of telematics devices.
WS103 set up requirements
WS Wireless Configurator (version 2.0.0 or above) installed on PC/Laptop, USB/RS232 converter cable
(part number 11165987), and an external power supply are required to set up the WS103 unit.
System configuration schematic
2
1
3
4
kwa1466185098236
1. USB/RS232 Converter cable (part number 11165987)
2. Clamp 15 (optional)
3. Can Bus network
4. External power supply
WS103 kit
WS103 kit (Part number: 11168245) components
Device
Description
Part number
WS103 kit
CONTROL, WS103 Wireless
11165988
CAN Cable M12 5-pin /open 5m
11149645
Protection Cap M12 Flange Plug
11169389
Wiring
When installing control system hardware, one of the most important things to consider is the type of
cable to be used for connecting together each component of the system.
C
Caution
Using incompatible accessories may damage your equipment. Incorrect selection or wiring of such cables
can cause a wide range of problems, including erratic or non-existent communication, an increased
danger of component damage due to freak voltages, or an increased chance of EMI (Electro Magnetic
Interference), all of which can have an adverse effect on the installation. If you are using other accessories
than those contained in the WS103 Kit, make sure that they are compatible with the devices.
Connectors
WS103 is equipped with the following connectors:
•
One main connector (CAN/Power, J-1)
•
One configuration connector (RS-232, J-2)
The antenna is integrated into the device housing, below the pin assignment of the two 5-pin M12
connectors.
User Manual
WS103 Remote Solution
System configuration
10 |
©
Danfoss | July 2016
AN00000339en-US0101
