•
PC-based Configuration Tool MCT 10,
enables the
user to configure the frequency converter from a
Windows™ based PC environment.
•
Danfoss VLT® Energy Box
software, for energy
calculation in HVAC applications.
•
Approvals.
Technical literature and approvals are available online at
www.danfoss.com/BusinessAreas/DrivesSolutions/Documen-
tations/TeDocumentation.
Danfoss VLT® Energy Box software is available at
www.danfoss.com/BusinessAreas/DrivesSolutions
, PC software
download area.
1.3 Symbols, Abbreviations and
Conventions
The following symbols are used in this manual.
NOTICE
Indicates highlighted information that should be
regarded with attention to avoid mistakes or operate
equipment at less than optimal performance.
*
Indicates default setting
AC
Alternating Current
AEO
Automatic Energy Optimization
AWG
American Wire Gauge
AMA
Automatic Motor Adaptation
°
C
Degrees Celsius
DC
Direct Current
EMC
Electromagnetic Compatibility
ETR
Electronic Thermal Relay
f
M,N
Nominal Motor Frequency
FC
Frequency Converter
HO
High overload
IP
Ingress Protection
I
LIM
Current Limit
I
INV
Rated Inverter Output Current
I
M,N
Nominal Motor Current
I
VLT,MAX
The Maximum Output Current
I
VLT,N
The Rated Output Current Supplied
by the Frequency Converter
LCP
Local Control Panel
N.A.
Not applicable
NO
Normal overload
P
M,N
Nominal Motor Power
PCB
Printed Circuit Board
PE
Protective earth
PELV
Protective Extra Low Voltage
Regen
Regenerative Terminals
RPM
Revolutions Per Minute
T
LIM
Torque Limit
U
M,N
Nominal Motor Voltage
Table 1.1 Abbreviations
Conventions
Numbered lists indicate procedures.
Bullet lists indicate other information and description of
illustrations.
Italicised text indicates
•
cross reference
•
link
•
footnote
•
parameter name, parameter group name,
parameter option
Introduction
VLT
®
DriveMotor FCP 106 and FCM 106 Design Guide
MG03M102 -
08/2015
5
1
1
