Micromon
Micromon
RS.8A.Y3.02
©
Danfoss
01-2003
9
EKS
EKS111 probe (-35 to +85°C)
Digital
NO
Normally open
NC
Normally closed
To set the units of measurement, repeatedly press ‘
↵
↵↵
↵↵
’ to scroll through the fields
until the Units field is highlighted.
Enter the units required using the ‘
’ or ‘
’ keys to scroll through the character
list and the’
' or ‘
’ key to move the cursor left or right respectively.
Note: This is a text field only and does not effect the operation of the system.
You can use the ‘
‘ and ‘
’ keys together to delete the character before the
cursor and ‘
‘ to change case. When the units have been set, press ‘
↵
↵↵
↵↵
’. The
edit box will move onto the next field.
Select the point as previously described. Repeatedly press ‘
↵
↵↵
↵↵
’ to scroll through
the fields until the High field is highlighted. Set this field to set the value at or
above which an alarm will occur by using the ‘
’ or ‘
’ keys to scroll through the
character list and the ‘
’ or ‘
’ key to move the cursor left or right respectively.
When the high temperature alarm point has been set, press ‘
↵
↵↵
↵↵
’. The edit box will
move onto the next field.
Repeat the operation for the Low field, to set the value at or below which an alarm
will occur. Press ‘
↵
↵↵
↵↵
’ to move the edit box onto the next field.
Repeat the operation for the Delay field. Set the length of time (in minutes) that the
fault must be present before an alarm is raised.
Log printouts are available for selected points on a timed or demand basis via the
print menu. 'Timed' means the Micromon is programmed to automatically print a
log at preselected intervals. A log printout can also be initiated via the ‘
‘ key on
the keypad (manual). When a log is printed only points with the log action field
appropriately set will be output. The available settings are:
Off
Set this point to OFF if you do not want this point to be
shown on any log printouts.
Timed
The point will be included only in a 'Timed' log printout.
Manual
The point will be included only in a 'Manual' log printout.
On
Set this option to ON if you require this point to be included in all
log printouts.
Repeatedly press ‘
↵
↵↵
↵↵
’ to scroll through the fields until the Log field is highlighted.
Use the '
' or '
' keys to set the required log action and press ‘
↵
↵↵
↵↵
’ to move the
cursor onto the next field.
Graph printouts are available for selected points on a timed or demand basis via
the print menu. 'Timed' means the Micromon is programmed to automatically print
a graph at preselected intervals. A graph printout can also be initiated via the ‘
‘
key on the keypad (manual).When a graph is printed only points with the graph
action field appropriately set will be output. The available settings are:
Off
Set this option to OFF if you do not want this point
graph to be shown on any graph printouts.
Timed
The graph for this point will be included only in a 'Timed' graph
printout.
Manual
The graph for the point will be included only in a 'Manual' graph
printout.
Alarm Settings
Log Action
Graph Action
Printout Options
Units of Measurement