Cable and cup replacement
The case (cup) will need to be removed to install the cable.
The label from the old case will need to be put back on the new case otherwise all information about the
joystick is lost.
The cable will need to be removed to install the new case.
Refer to
on page 4, at step 4 it is possible to replace either the cable or cup.
1. Carefully take the cable connector out through the grommet hole, replace either the cup or cable and
insert the cable again through the grommet hole.
2. Align the two grooves before tightening the cup back on.
Service Manual
JS1-H Serviceability for IP54 Joysticks
HR1, ST7, PR2, ST2, PR7
©
Danfoss | July 2019
AX311058842185en-000103 | 9
