Danfoss JS1-H Serviceability, Руководство по обслуживанию

Страница: 17 / 24

Grip removal from base
It is possible to remove the HR1 grip from the base, after step 2 under PCBA removal on page 6.
1. Remove the two plastic covers to access the setscrews.
2. Loosen the two setscrews to remove the grip from the base.
Use: Allen Key 2.5 mm, Torque: 2.8 Nm
To tighten the grip back on, use the tool and torque noted.
Boot, cup and cable replacement
The grip will need to be removed as described in Grip removal from base on page 17. After removing the
grip, refer to Boot replacement on page 8 to replace the boot if desired.
The case will need to be removed to install the cable.
The label from the old case will need to be put back on the new case otherwise all information about the
joystick is lost.
The cable will need to be removed to install the new case.
Refer to Cup and cable disassembly on page 4, step 4, in order to replace either the cup or cable.
Service Manual
JS1-H Serviceability for IP54 Joysticks
HR1
© Danfoss | July 2019 AX311058842185en-000103 | 17