Danfoss FCM305 56, Инструкция по эксплуатации

Страница: 38 / 132

FCM 300 Series
MG.03.B6.2G - VLT is a registered Danfoss trademark
LCP-2
Remote Mounting Kit continued....
Local Operation Pad (LOP)
The LOP is wired directly to the X101 control
terminals. The LOP provides speed control, a start/
stop function and, depending on how it is wired and
programmed, the following three functions:
1. Dual speed operation
2. Dual mode operation (Uses 2-Set-up Menus)
3. Dual direction operation (For forward or reverse)
Color of wire Color of wire Color of wire Color of wire Color of wire T T T T Terminal erminal erminal erminal erminal Function Function Function Function Function
White 2 Reference
Brown 3 Reset
Orange or Gray 4 See table under button
Green 5 See table under button
Red 6 +24V
Yellow 7 +10V
Blue 8 Ground
W W W W W iring iring iring iring iring
Function/settings Function/settings
Function/settings Function/settings Function/settings
Key (Start) Key (Start)
Key (Start) Key (Start) Key (Start)
Key (Start) Key (Start)
Key (Start) Key (Start) Key (Start)
Key (Stop) Key (Stop)
Key (Stop) Key (Stop) Key (Stop)
Default - Dual speed operation Default - Dual speed operation Default - Dual speed operation Default - Dual speed operation Default - Dual speed operation Run on set Run on Stop (and
(connect orange wire): (connect orange wire): (connect orange wire): (connect orange wire): (connect orange wire): reference 10 Hz** reset* - if trip)
No changes to factory setting. (+/-) jog speed
Function 2 - Dual mode operation Function 2 - Dual mode operation Function 2 - Dual mode operation Function 2 - Dual mode operation Function 2 - Dual mode operation
(connect orange wire): (connect orange wire): (connect orange wire): (connect orange wire): (connect orange wire): Run with Run with Stop (and
Select desired modes of operation Setup 1 Setup 2 reset* - if trip)
in Setups 1 and 2 (use para. 4-6)
Parameter 335 = 18 (select Setup)
Function 3 - Dual direction operation Function 3 - Dual direction operation Function 3 - Dual direction operation Function 3 - Dual direction operation Function 3 - Dual direction operation
(connect grey wire): (connect grey wire):
(connect grey wire): (connect grey wire): (connect grey wire): Run Run Stop (and
Parameter 335 = 10 (start reversing) forward reverse reset* - if trip)
Parameter 200 = 1 (both directions)
*If no reset is required, **or set parameter 213
do not connect the brown wire
At power up the unit will always be in stop mode.
Set reference will be stored during power down. If
permanent start mode is desired, connect terminal
6 to terminal 4 and do not connect orange/gray
wire to terminal 4. This means the stop function on
LOP is disabled.
NOTE!
After wiring the LOP, cut off or isolate any
excess wire.
■
■
Operation
7-4