Danfoss ET5070, Руководство оператора, Страница: 45 / 96

WARNING!
Risk of squeezing!
When the die system closes, there is a risk of getting squeezed
between the dies.
• Only replace the dies when the motor is deactivated.
3. Use the die key to press and hold the locking pin (2) in the basic
die (3) backward.
4. Use the holding pin to place the crimping dies in the locating
hole (1).
5. Remove the die key and release the pressure on the locking pin
(2) - the crimping die is now fixed.
Always mount a complete set of identical crimping dies with the
same label and diameter. One set comprises eight crimping dies or
seven crimping dies and one associated marking die.
Removing the crimping dies
1. Open the crimping tool fully.
2. Deactivate the machine at the power switch.
WARNING!
Risk of squeezing!
When the die system closes, there is a risk of getting squeezed
between the dies.
• Only replace the dies when the machine is deactivated.
3. Hold the crimping die to be removed with one hand.
4. Use the die key to press and hold the locking pin (2) in the basic
die (3) backward with the other hand.
5. Remove the crimping die concerned.
6. Remove the die key and release the pressure on the holding pin
(2).