Danfoss EC-C1200-450, Руководство пользователя

Страница: 32 / 69

Figure 13. Removing the X1-connector
Preparations
Make sure that the chosen installation place ful lls the environmental requirements speci ed
for the electric device.
Protect the electric device against corrosive gases, liquids, conductive contaminants (such as
condensation, carbon dust, and metallic particles) and sprays or splashing water from all
directions.
Protect the electric device in high humidity, salty or chemical content environments with
suitable additional enclosure.
The mounting place and mounting interfaces should be sufficient to carry the weight of the
electric device.
Make sure that the electric device has sufficient mounting and operating clearances for
maintenance work.
Installation procedure may vary from that shown in this user guide. All steps must be included
in the procedure, although the order of the steps can be different.
Installation procedure
1. Prepare the installation place and make sure that it meets the requirements for the product.
2. Lift and support the electrical device for the mounting. Refer to Chapter
Lifting .
3. Install all appropriate mounting screws, do not tighten the screws until they are aligned and
pre-installed. See the tightening torques from Chapter Tightening torques .
4. Connect the cooling system. See chapter Cooling connections or the Main dimension drawing
for connection details. Make sure that there are no air pockets in the cooling channels and that the
coolant goes freely in and out. Make sure that the cooling system operates correctly.
EC-C1200-450
5. Installation
| BC265735231757en-000109
©
Danfoss | Produced By: Danfoss Power Solutions | January 2019 | 31