Danfoss DHP-M, Пусконаладка

Страница: 20 / 40

Two heat pumps, setting up primary and secondary functionality
First ensure that the primary is correctly set up with a valid IP number in the "Network
settings" menu. (You should NOT use dhcp.)
In the "primary/secondary" menu ensure that the unit Id and the number of secondary
units is correctly configured. Once the primary has been correctly configured. Proceed
to setup the secondary unit.
On the secondary unit, go to the network settings menu and configure the machine to
be on the same subnet.
Finally, in the "primary/secondary" menu, configure the secondary unit.
No external network connection to the system. Ethernet cable: Standard Cat 5 network cable, RJ 45.
1 2
1. Primary (controlling) heat pump with IP address e.g. 192.168.0.100
2. Secondary heat pump with IP address e.g. 192.168.0.102
The secondary heat pump must always point to the primary heat pump IP address.
Commissioning DHP-M
VIJSE302 Danfoss Heating Solutions
20