Danfoss DHP-M, Пусконаладка

Страница: 19 / 40

5.6 Heating Settings
In Heating settings, you can set seasonal stop, min/max supply line temperature and comfort factor.
The Comfort factor (0 - 3) influences the desired Supply line (HP) value. If the Comfort factor is set to for example 3, an increase of the of
the Comfort wheel setting with +1 will result in an increase of the supply line temperature with +3 ºC.
Default value is 1x.
1. Press on the Start screen to open the Menu screen.
2. Press
3. Press
if the Heat settings window is not shown.
4. Make the desired changes.
5. Confirm settings by pressing
5.7 Network connection, Online and setting up primary and secondary functionality
Danfoss Online
The heat pump is factory prepared for monitoring (and as an additional service being operated) remotely via internet. (Danfoss Online)
In order to use the Danfoss Online service:
▪
Make sure that there is an available internet connection (router or equivalent) in the building
▪
An account and registration is required to use the Danfoss Online service.
For more information, see:
www.documentation.heatpump.danfoss.com
▪
Make a note of the heat pump MAC-address. The MAC-address is available in the Network menu in the display
Bear in mind that firewalls, deficient connections etc. can cause problems that will prevent desired functionality. Some operators, munic-
ipal networks etc. does not allow traffic through their firewalls.
Contact the internet service provider or network administrator if there are any such problems.
Connecting to internet
Connect the commissioned heat pump to an existing internet connection (router or equivalent). Use the RJ45 connection placed below
the display (CM module) behind the front panel. Use a patch cable (not cross over cable).
Network settings
In the Network settings DHCP (factory default) or Static IP-address can be selected. For DHCP, the router in the local network will provide
IP-address etc. See Menu settings .
If Static is selected, then IP-address, Network mask, IP gateway, DNS1 and DNS2 must be set manually. See Menu settings .
Commissioning DHP-M
Danfoss Heating Solutions VIJSE302
19