Danfoss DHP-M, Пусконаладка

Страница: 26 / 40

7 Starting and tuning the system
N
In hot water operating mode and heating operating mode, the com-
pressor will run for 20 minutes at about 1,500 rpm before control
starts (factory settings). To adjust factory settings in the heat pump
display, go to the settings for heat pump: Compressor gear shift delay.
7.1 Enable functions
N
Functions not activated/enabled from factory must be enabled and
activated in the control system before they can be used.
Below is an example where the Distribution Circuit function is enabled.
Other functions are enabled in a similar way.
1. Press in the upper left corner of the Start screen.
2. Press
.
3. Continue with to the menu page for Mix valves.
4. Press the text Distribution Circuit 1.
5. Press
to enable the Distribution Circuit 1 function.
6. Adjust the settings appropriately.
7. Press
to confirm the setting.
8. Press to return to the Menu screen.
7.2 Activate / deactivate functions
N
Functions not activated/enabled from factory must be enabled and
activated in the control system before they can be used.
Below is an example where the Distribution Circuit function is deactivated.
Other functions are activated in a similar way.
1. Press in the upper left corner of the Start screen.
2. Press
.
3. Continue with to the menu page to activate/deactivate Distribution Circuit 1.
4. Press
to activate Distribution Circuit 1 or press to deactivate Distribution Circuit 1.
5. Press to return to the Menu screen.
7.3 Selecting operating mode
N
The heat pump has a starting time of about 5 - 10 minutes.
The delay does not apply to the auxiliary operating mode.
Commissioning DHP-M
VIJSE302 Danfoss Heating Solutions
26