Danfoss 088U0221, Инструкция

Страница: 5 / 20

5 © Danfoss 03/2011 VIUHM602 Danfoss Heating Solutions
Instruction CF-RC Remote Controller
2.3 Activate Install mode on Remote Controller (fig. 1)
• When the batteries have been connected, follow the installation guide, beginning with
the selection of language.
• After the installation process, set time and date by using the up/down selector  and
the left/right selector

. Confirm settings with OK.
• The installation process is concluded with the opportunity to name the rooms in which
the room thermostats are placed. This makes access to and handling of the system very
easy.
• In the Name rooms menu, activate the Change with soft key 2 (  ) to change the de-
fault room names (e.g. from “MC1 Output 1.2” to “Living room”), and confirm with OK.
You can also use the
Spell….
menu to create other names.
• When the installation is finished a start up screen with actual time and date will be
shown in the display. The screen also shows actual temperature in the first room on the
rooms list (to select another room for the start screen, see chapter 5.1.2).
Note: Keeping a button activated during settings will make the value change faster.
3. Transmission Test
3.1 Initiate a transmission test on Remote Controller
Menu

Setup

Link test: From the start-up screen, select Link Test to activate a test of
the wireless transmission between Master Controller and Remote Controller. The status of
the link test will be displayed right after the test has been carried through.
If the link test is not successful:
• Try to relocate Remote Controller in the room.
• Or install a CF-RU Repeater Unit, and place it between Master Controller and Remote
Controller.
Note: The link test may take a few minutes, depending on the size of the system.