Webpage
Lyra Digital Mixer from D&R Phone +31 294 418014, email:
Page 44
The 'Advanced Input Setting' screens for the analog inputs, the digital inputs and the Cobranet inputs are
the same except for a few option, which are grayed out if the function is not present. The settings for the
MIC inputs are also the same except for one section.
Input Correction
Phase
Inverts the phase of the signal.
Swap L/R
Exchanges the left and the right audio channel.
L to LR
The signal from the left channel is copied to the right channel.
R to LR
The signal from the right channel is copied to the left channel.
Module Function
Level/Headroom Trim (DSP)
The possibility to trim the level of the source from -20dB to +20dB.
MIC Gain (MIC Only!!)
The possibility to trim the level of the MIC inputs from 0dB to +60dB.
EQ Active
Enables the EQ functionality.
Dynamics Active
Enables the dynamics functionality.
Remote
Type
You can select continuous and pulse for the remote signal. Continuous changes state only
at action and pulse changes state shortly after action.
Action
Select the action that triggers the remote. Fader and ON switch means that the remote will
only be triggered when both the fader is open and the channel is ON. With this option
disabled you get a fader or ON switch situation. This means trigger occurs at fader ON
and ON switch independently.
On switch
Local Function Audio On/Off enables you to disable the audio function of the On switch. This way you can
use the On switch only to trigger the remote.
Trigger On Remote causes a trigger when the channel is enabled by On switch. Trigger
Off remote causes a trigger when the channel is disabled by the On switch.
Note:
When the audio function is disabled you will get a retrigger signal when
pressing the ON switch regardless the settings for trigger On/Off remote.
Action
Latching means that the On switch holds its state until pressed again. Momentary means
that the On switch changes state again at the moment of release.
Remote Buss Here you can select if the ON switch must activate a remote Buss (1..4)
CUE Switch
Local Function Same for On switch => Function
Action
Same for CUE switch => Action
Remote Buss Here you can select if the CUE switch must activate a remote Buss (1..4)
Fader
Local Function With the Trigger On/Off remote option you can select if you want a trigger when the
fader opens, fader closes, fader opens and closes and fader closes.
Remote Buss Here you can select if the fader must activate a remote Buss (1..4)
Cobranet
Local Function Determines how the incoming cobranet remote must be treaded. NOTE: Because the
cobranet remote always is continuous at least one option must be marked for the
cobranet remote to be passed on. When no options are marked the remote will not be
passed through.
Remote Buss Here you can select if the incoming cobranet remote must activate a remote Buss
(1..4)
Input Active Generates
Redlight1..2
Option to activate Redlight 1..2 when input goes on air.
CRM Mute
Option to mute CRM when input goes on air.
Studio Mute
Option to mute Studio output when input goes on air.
Total CUE Reset
Option to do a total CUE reset when input goes on air.
Local CUE Reset
Option to do a local CUE reset when input goes on air.
