Danaher Motion Standalone MMC, Руководство по оборудованию

Страница: 57 / 182

Standalone MMC Hardware Manual 57
Danaher Motion
version 15.1
Standalone MMC Control
Figure 4-4: General I/O Port Breakout Box Dimensions
4.5.4.1 DC Output Operation
The General I/O Port provides 16 source-only 24 Vdc outputs. Each of the 16 outputs
on the general I/O connector is a solid state switch rated at 250 ma. An example of
connecting the DC Outputs to loads is shown in
Figure 4-5 .
There are two groups of eight outputs: group A = output 1 through output 8, group B =
output 9 through output 16. Each group is capable of detecting a short circuit
condition. When a short circuit condition is sensed, all outputs in the group are turned
off and remain off for approximately 100 ms regardless of ladder activity. After 100 ms,
the ladder again controls the outputs. In addition, each output is protected with internal
Table 4-22: General I/O Port Breakout Box and Cables
a
a. The Breakout Box for the General I/O connector can be attached to the “GEN
I/O” port on the MMC Control, and on the “GEN I/O A” and “GEN I/O B” ports
on the MMC 32 In/32 Out Expansion module. The pinouts on the terminal
strip interface provide a one-to-one transfer of the signals from the connector
to the respective pin(s) on the terminal block. The connector pins marked with
the “ground” symbol on the screw connector are connected to the “D” con-
nector shell for shield grounding purposes.
Description Length Part Number
MMC Gen I/O Breakout Box N/A M.1016.2532
MMC Gen I/O & Aux I/O Connector to
Breakout Box Cable
.3 M (1 ft) M.1016.2539
MMC Gen I/O & Aux I/O Connector to
Breakout Box Cable
.6 M (2 ft) M.1016.2540
MMC Gen I/O & Aux I/O Connector to
Breakout Box Cable
.9 M (3 ft) M.1016.2541
1.875”
2.625”
3.940”
1 22
23
44
5.312”