Dalsa Piranha3, Руководство пользователя

Страница: 17 / 91

Piranha 3 User Manual
DALSA 03-032-10216-02
17
!
!
2.2.2 Power Connector
Figure 4: Hirose 6-pin Circular Male—Power Connector
Hirose 6-pin Circular Male
5
4
6
2
3
1
Mat ing Par t: HIRO SE
HR10A -7P-6S
The camera requires a single voltage input with a +12V to +15V operating range (+11V to
+16V absolute maximum range). The camera meets all performance specifications using
standard switching power supplies, although well-regulated linear supplies provide
optimum performance.
WARNING: When setting up the camera’s power supplies follow these guidelines:
• Protect the camera with a
fast-blow fuse
between power supply and camera.
• Do not use the shield on a multi-conductor cable for ground.
• Keep leads as short as possible to reduce voltage drop.
• Use high-quality
linear
supplies to minimize noise.
• Use an isolated type power supply to prevent LVDS common mode range violation.
Note:
Performance specifications are not guaranteed if your power supply does not meet
the +12V to +15V requirements.
WARNING: It is extremely important that you apply the appropriate voltages to your
camera. Incorrect voltages will damage the camera. Protect the camera with a fast-blow
fuse between power supply and camera.
DALSA offers a power supply with attached 6’ power cable that meets the Piranha3
camera’s requirements, but it should not be considered the only choice. Many high
quality supplies are available from other vendors. DALSA assumes no responsibility for
the use of these supplies.
Visit the www.dalsa.com Web site for a list of companies that make power supplies that
meet the camera’s requirements. The companies listed should not be considered the only
choices.
2.2.3 Camera Link Data Connector
Figure 5: Camera Link MDR26 Connector
MDR26 Female
1
14
13
26
M at ing Par t : 3M 334-31 ser ies
C able: 3M 14X 26-SZ LB-X X X -0LC * *
**3M part 14X26-SZLB-XXX-0LC is a complete
cable assembly, including connectors.
Unused pairs should be terminated in 100
ohms at both ends of the cable.
Table 6: Hirose Pin Description
Pins Description
1,2,3 +12 to +15V
4, 5, 6
GND