DF3000IP(-DN) / DF3000IP(-DN) CasinoCam
®
30
Dallmeier electronic
9.8.2
Configuration for SmartFinder
If SmartFinder is used, some restrictions and additional options must be taken into
consideration.
¾
Open the Motion detection dialog via Common settings > Motion detection ....
¾
Please note the explanations
below.
¾
Activate the Checkbox Enable
SmartFinder.
¾
Set the Sensitivity (drop-down
box).
¾
Enter the Fade Out Time in
seconds.
¾
Finally confirm with OK.
If SmartFinder is used, the motion detection system initially acts as described above. The
configuration of the Sensitivity (slider) and the SAD value is set to a fixed value, however.
The Sensitivity (drop-down box) in this case refers to a different function (see below).
Fade Out Time
The Fade out time (seconds) defines how long an object (linked changed picture sectors)
is valid. If another object is detected in the same place during this period, it will not be
assessed as a new event but will be discarded.
This setting allows the user to reduce the number of events triggered by the repeated
movement of the same object.
Example:
0 sec.
Ö
A new event for every object
Ö
A very large number of events
Sensitivity (drop-down box)
This function checks the extent to which an old (still valid) object and a new object overlap.
If the non-overlapping area is larger than an (internally) set value, the new object will be
assessed as a new event.
This function therefore represents a refinement of the mechanism set by the fade out time.
Example:
Very sensitive
Ö
Event, even if the new area is small
Ö
Lots of events
Very insensitive
Ö
Event only if the new area is very long
Ö
Few events
Fig. 9-12
