dallmeier DDF4510HDV-IM, Руководство по установке и настройке

Страница: 30 / 105

DF4510HD | DF4910HD | DDF4510HDV-IM/-SM | DDF4910HDV-IM/-SM
www.dallmeier.com 30
Step 4

Connect the required cables to the connectors of the camera module
(see Fig. 5-7 and chapter “ Pin Assignment ” on page 96).

If necessary, connect a CVBS monitor to the video preview output ( Fig. 5-4 ).

If PoE (Power over Ethernet) is not available, first connect the camera to a suitable
power supply unit and then connect the power supply unit to the mains socket.

Align the camera with your scene using the 3-axis mount and set the focal length and
focus (loosen the corresponding locking screws before making any adjustments and
tighten them again when finished).

Disconnect the CVBS monitor from the video preview output.

Attach the trim ring to the housing and tighten the 3 housing screws using a T20 torx
wrench.
Housing screw
(T20 Torx)
Locked ceiling clamp Locked ceiling clamp
Suspended ceiling
Trim ring with bubble
Fig. 6-6
6.2.2 Surface Mount Variants (SM)
The housing base is mounted with 3 screws (Ø 4 mm) to the ceiling/wall.
You need:
• T20 torx wrench
• Marking tool (e.g. awl)
• 3 mounting screws (Ø 4 mm)
•
3 anchors
• Electric drill
• Screwdriver

Unscrew the 3 housing screws ( Fig. 5-5 ) using a T20 torx wrench and remove the
housing.

Mark the drill holes on the ceiling/wall using the 3 pre-drilled mounting holes of the
housing base ( Fig. 5-6 ) as a template.

At the marked locations, drill holes fitting the screws/anchors to be used.

Push anchors suitable for the ceiling/wall material into the drill holes.

Run the required cables suspended from the ceiling/wall through a PG16 cable gland.