– 16 –
Set the
Target Dimensions
as either
Automatic
or
Manual
to position the incoming video
signal on the display. If
Automatic
is chosen, the controller handles content placement
and positioning and the dimensions will match the configured display size. If
Manual
is chosen, the operator manually defines the content placement and positioning.
This
feature should not be used unless instructed to do so by Daktronics technicians.
Refer to
.
Note:
Take care to avoid shifting the output from the display’s viewable area.
Figure 32:
Input - Target Dimensions
Test Pattern
Select
Test Pattern
from the
Display Mode
drop-down menu to open the
Test Pattern
drop-down menu and the
Minimum Hold Time (Seconds)
field. Refer to
. Test patterns are used during display installation and troubleshooting, and to
test display operation when no video sources are available.
Figure 33:
Input - Test Pattern Display Mode
After selecting a test pattern from the drop-down menu and entering the
Minimum Hold
Time
, click
Save
to start the test pattern. The
Minimum Hold Time
sets the time between
pattern changes for test patterns that consist of multiple patterns.
Note:
Test patterns play immediately when selected, interrupt any currently playing
video, and continue to run until the
Display Mode
is changed.
Change the
Color Adjustment
settings, the
Source Dimensions
, and the
Target
Dimensions
.
Note:
Take care to avoid shifting the output from the display’s viewable area.
Figure 34:
Test Patterns
