7
MAN#650508B
FUNCTION SWITCH
The factory speedometer push button switch is used as the main function switch. The function switch allows
access to all of the mileage, RPM, and performance information. Pressing and releasing the function switch toggles
through the different displays. Pressing and holding the switch for about two seconds will switch the focus between the
speed message display and tach message display. The screen with the current switch focus has an arrow in the upper
right corner. When holding the switch the screen without focus will switch to reverse image. Release the switch while this
is shown to change screens. Pressing and holding the switch for about four seconds will reset the current display. The
display sequence for the speedometer is as follows:
Speed message displays
DESCRIPTION
ODOMETER
Odometer reading (0-999,999)
A MILES
Trip A odometer reading (0-9999.9)
B MILES
Trip B odometer reading (0-9999.9)
S miles
(when enabled)
Distance to next service (0-9,999,or ---- when past due)
KM/H
Alternate speed unit conversion
e miles
(when enabled)
Distance to empty
Oil temp
(when gauge is not present)
E
ngine oil temperature
Oil PSI
(when gauge is not present)
Engine oil pressure
voltage
(when gauge is not present)
System voltage
Fuel %
(when gauge is not present)
F
uel level
Air temp
Outside temperature from factory sensor
Tach message displays
DESCRIPTION
Clock/gear
12 hour clock display and gear position
HOURS
Hours gauge has been on with engine running (0-999.9)
Oil temp
(when gauge is not present)
E
ngine oil temperature
Oil PSI
(when gauge is not present)
Engine oil pressure
voltage
(when gauge is not present)
System voltage
Fuel %
(when gauge is not present)
F
uel level
Air temp
Outside temperature from factory sensor
Performance readings (can be enabled on either display)
HI SPEED
High speed recall
0-60 MPH
0-60 mph time in seconds
1/4 mi spd
Speed at end of ¼ mile (trap speed)
1/4 mi TIME
Time to travel ¼ mile from standing start
HIGH RPM
High RPM recall
MBM displays (optional)
MBM (Motorcycle Bus interface Module) readings for connected
modules
CLOCK SETUP
To set the clock, the clock/gear display must be shown and active.
If the tach message display does not have a small triangle in the upper right corner, press and hold the switch until
the screen switches to a reverse image and then release.
If the clock/gear display is not shown, press and release the switch until it is shown on the tach message display.
To enter the clock setup, press and hold the switch until the hours begin flashing.
Press and release the switch to change the hours.
When the hours are correct, press and hold the switch until the minute 10’s begin flashing.
Press and release the switch to change the minute 10’s.
When the minute
10’s are correct, press and hold the switch until the minute 1’s begin flashing.
Press and release the switch to change the minute 1’s.
When the minute 1’s are correct, press and hold the switch until it stops flashing.
