3
MAN#650508B
Next you are ready to install the new gauges into the fairing. Install the gauges and secure using the original hardware
that was removed plus the provided clamps, gaskets, screws and nuts.
Be sure the alignment tab on the clamp lines up with the notches in the fairing. Some fairings may only have one notch;
line up at least one tab on the clamp with the notch in the fairing, this will ensure the gauges are centered and aligned
correctly. Be sure to check alignment from the front before final torqueing.
Speedometer and Tachometer Oil PSI, Oil Temp, Voltmeter, and Fuel Level
OIL TEMPERATURE SENSOR
The supplied oil temperature sensor replaces one of the oil pan plugs. You can do this at an oil change so you do not
have to worry about losing oil, or be quick and you should only lose a small amount of oil. First locate the allen head plug
on the front bottom side of the oil pan. The plug is on the right of the oil pan drain plug that is used to drain the engine oil
for an oil change. It is a 3/8” NPT allen head plug that should be flush with the oil pan. See photo for the correct plug.
NOTE: Check oil level after install of this sensor, refill oil as needed
Bottom of oil pan Remove 3/8”npt allen plug
