Dakota Digital BIM-01-2-HLLY, Руководство пользователя, Страница: 5 / 12

[5] MAN #650588D
VFD3, and VFD3X Setup Continued:
Obtaining RPM from the BIM-01-2-HLLY
•
Hold the SW1 switch from the instrument system control box while turning the key on.
o
The speed display should show

and the message display should show
SETUP
.
•
Release SW1. Tap SW1 until

and TACH are displayed.
•
Press and hold SW1 for at least 3 seconds, until
 changes to “-”. The displays should show 
and T CAL .
•
Press and hold SW1 for at least 3 seconds, until
 changes to “-”. The speed display will show the current
setting.
•
Tap SW1 until

and T CAL are displayed.
•
Press and hold SW1 until “-” and
DONE are displayed.
•
Tap SW1 until

and DONE are displayed.
•
Press and hold SW1 until “-” and
DONE are displayed.
Obtaining engine temperature from the BIM-01-2-HLLY
•
Hold the SW1 switch from the instrument system control box while turning the key on.
o
The speed display should show

and the message display should show
SETUP
.
•
Release SW1. Tap SW1 until

and
WATER
are displayed.
•
Press and hold SW1 for at least 3 seconds, until
 changes to “-”. The displays should show 
and SENDER .
•
Press and hold SW1 for at least 3 seconds, until
 changes to “-”. The speed display will show the current
setting.
•
Tap SW1 until

and BUS F (Fahrenheit) is displayed.
o
Tap SW1 once more for

and BUS C (Celsius) if desired.
•
Press and hold SW1 until “-” and
DONE are displayed.
•
Tap SW1 until

and DONE are displayed.
•
Press and hold SW1 until “-” and
DONE are displayed.
Obtaining oil pressure from the BIM-01-2-HLLY (not Sniper, if available in HP/Dominator)
•
Hold the SW1 switch from the instrument system control box while turning the key on.
o
The speed display should show

and the message display should show
SETUP
.
•
Release SW1. Tap SW1 until

and
OIL
are displayed.
•
Press and hold SW1 for at least 3 seconds, until
 changes to “-”. The displays should show 
and SENDER .
•
Press and hold SW1 for at least 3 seconds, until
 changes to “-”. The speed display will show the current
setting.
•
Tap SW1 until

and BUS are displayed.
•
Press
and hold SW1 until “-” and
DONE are displayed.
•
Tap SW1 until

and DONE are displayed.
•
Press and hold SW1 until “-” and
DONE are displayed.