[3]
MAN #650588D
Terminator, HP and Dominator EFI speed input setup, continued:
If speed sensor is connected to Input #1 on J1A, pin A12
•
Using the Holley computer software, the Input #1 must be labeled as
Speed.
•
Ensure the
Speed
input is mapped to a frequency (
F
) Input Type on the Holley Pin Map.
•
These settings will enable the Holley to send speed out on the Racepack CAN
To monitor Input #1 on J1A, pin A12 you must enable the
setting within the BIM:
•
Hold button on BIM-01-2-HLLY and turn ignition on, then release the button.
•
Tap button to display
(Input).
•
Hold button until a dash (
–
) is displayed, and then release.
•
Tap the button to display
•
Hold button until a dash (
–
) is displayed, and then release.
•
Tap button to display
, then hold to save.
Sniper EFI system setup:
Data that should be available: RPM, Engine temp, Intake/manifold temp, MAP/boost, A/F ratio.
Holley system setup:
No configuration within the Sniper EFI system or software is required.
BIM-01-2-HLLY setup:
The BIM must be configured to understand it will be talking to the Sniper EFI
•
Hold button on BIM-01-2-HLLY and turn ignition on, then release the button.
•
Tap button to display
(System).
•
Hold button until a dash (
–
) is displayed, and then release.
•
Tap the button to display
(Sniper)
•
Hold button until a dash (
–
) is displayed, and then release.
•
Tap button to display
, then hold to save.
Note:
Speed Input is not a selectable menu option with
selection
– Sniper does not send speed.
Terminator X, X Max EFI system setup:
Data that should be available: RPM, Engine temp, Intake/manifold temp, Boost only, A/F ratio, Oil pressure,
Fuel pressure.
Terminator X Max: Reads everything as the Terminator X, plus Vehicle speed.
Holley system setup:
No configuration within the Sniper EFI system or software is required.
BIM-01-2-HLLY setup:
The BIM must be configured to understand it will be talking to the Terminator X, X Max.
•
Hold button on BIM-01-2-HLLY and turn ignition on, then release the button.
•
Tap button to display
(System).
•
Hold button until a dash (
–
) is displayed, and then release.
•
Tap the button to display
(Terminator X)
•
Hold button until a dash (
–
) is displayed, and then release.
•
Tap button to display
, then hold to save.
EFI MAP/boost:
This module is programmed to monitor MAP(PSI/inHg) and boost (PSI/inHg) data broadcasted on the Holley EFI. MAP
and boost will both be displayed with the boost label on our system. MAP is the default reading preset from the factory. If
you wish to monitor boost pressure you must enable the
(boost) option through the setup menu. Please see setup
steps on page 10.
Note:
Terminator X will not show MAP, only boost PSI readings. Speed input is not a selectable menu option with
selection.