Dake Corporation
724 Robbins Road
Grand Haven, MI 49417
www.dakecorp.com
8
REV012019
ELECTRICAL CONNECTION
Before connecting the machine to the main power, make sure that the installation has a
disconnected box.
The machine is not equipped with an electrical plug, the customer must provide a suitable plug
for the machine. See diagram below for wire connection. (Green/Yellow wire = Ground)
CHOOSING A BLADE
First the pitch of the teeth must be chosen, suitable for the material to be cut, according to these
criteria:
•
Parts with a thing and/or variable section such as profiles, pipes, and plates, need fine
toothing, so the number of teeth used simulations cut.
•
Parts with solids sections need wide spread toothing penetration.
•
Material made of soft plastic, light alloys and mild bronze also require coarse toothing.
•
Attached to the on/off switch on the machine you will find a blade pitch calculator (part
number 71756) with instructions on how to use.
OPERATION
Use recommendations:
•
This machine has been designed to cut metal building materials with different shapes,
profiles used in workshops and mechanical structural work.
•
Only one operator is needed to use the machine.
•
Before starting each cutting operation, ensure that the part is firmly gripped in the vice
and that the end is suitably supported.
•
Do not use cutting blades of a different size from those states in the cutting capacity
section.
•
If the cutting blade gets stuck in the work piece, release the blade ON button
immediately, switch off the machine and open the vise slowly. Remove the part and make
sure that the cutting blade and/or teeth are not damaged or broken.
•
Before carrying out any repairs on the machine, consult the distributor or DAKE.
L1
L2
Ground
