DAITEM 473-29X, Руководство по установке

Страница: 15 / 44

5.4 Testing the radio link between the dialler and the image transmission detector(s)
For each image transmission detector, we recommend you check the radio link with the GSM/GPRS dialler (we advise you to move away
slightly, placing the product at least 2 m from the GSM/GPRS dialler). For lasting reliability, it is essential to carefully check each radio link,
as explained below, once all the products have been installed:
1. Dialler in installation mode 2. Briefly press the test button on the
detector. 3. The dialler performs the test:
• long beep, test OK,
• 3 short beeps, test not OK.
15 s max sliding
bar graph
Install mode
Programming
Test Com HD
IIIIIIIIIII
5.3 Programming the dialler to recognise image transmission motion detectors
IMPORTANT
• Both the dialler (for image transmission) and the control panel (for intrusion event transmission) must be programmed to recognise the
image transmission motion detectors.
• The dialler can only be programmed to recognise the image transmission motion detectors (up to 40) if it has already been programmed
to recognise the control panel.
• The dialler automatically allocates a number during recognition programming. Consequently, the same detector can be recognised by
the control panel as number 10 and recognised by the GSM dialler as number 6.
Programming Display Actions to be performed
to be performed
Putting the GSM
Select the Programming menu using the
L
and
M
keys,
dialler in recognition then press OK
programming mode
Select the General menu using the
L
and
M
keys,
then press OK
Select the Radio test menu using the
L
and
M
keys,
then press OK
Select Recog prog programming then press OK
Press then on the dialler
Press and hold the test button on the detector until the dialler responds with
“Detector n° X” (X = 1 to 40)
Install mode
Programming
Programming
General
General
Radio test
Radio test
Recog prog
Recog prog
IIIIII
Recog prog
“Detector n° X”
IMPORTANT
• If an error occurs during the recognition programming, the transmitter beeps 3 times. When this occurs, programming should be
performed again from the start.
• In case of repeated failure, please proceed as follows:
1. power off the control panel and the radio repeater relay(s) if any in the installation,
2. recognition programming should be carried out again from the start.
The red LED flashes
twice for 2 s.
General
Radio test
IMPORTANT: if the radio link has not been established (no “Test Com HD” display), all the recognition programming must be performed
again.
15
INST
ALLA
TION
MODE