DAITEM 473-29X, Руководство по установке

Страница: 14 / 44

14
Checking recognition programming
When checking that devices have been programmed for recognition,
the control panel issues the following voice messages in the order given:
• control devices,
• intrusion detectors,
• sirens.
To check all devices programmed,
press the following keys on the control panel:
1 1
Example:
“beep, control device 1,
beep, control device 2,
beep, detector 1, group 2, immediate,
beep, siren 1”
INST
ALLA
TION
MODE
1
then to
10 s max.
Press
*
then #
on the keypad
built into the
control panel
Press and hold the “test”
button on the motion
detector until the control
panel responds The control panel waits
for you to select the
group:
1 to 8 . Use the control
panel keypad to make the
selection.
Select an immediate time
delay.
Use the control panel keypad
to make the selection.
The control panel
issues a voice
message to confirm
detector recognition
programming
“time delay?”
8
)
)
)
)
)
“beep, detector
X, group?”
“beeeep, beep,
detector X,
group Y,
immediate”
5.2.2 Recognition programming with a control panel fitted with a software version below to 1.15.6
To perform recognition programming, the following steps must be followed:
• Programming the control panel to recognise the detector
• Programming the detector to recognise the control panel
Press and hold the test
button on the detector until
the control panel responds
Press and hold
*
on the
control panel until the detector
LED lights up for 2 s.
The red LED on the detector
lights up for 2 s to confirm
recognition programming.
)
)
)
)
)
“beep, detector
X, group?”
10 s max. 2 s min.
0