9
8.
Press the PROGRAMMING
START BUTTON. The program
setting is now finished.
(NOTES)
• Unless the button is pressed within 20
minutes, the display will automatically
revert back to the original state. In this
case, setting contents to the point where
the TIMER ON BUTTON (or HOLIDAY
SETTING BUTTON or BUTTON FOR
COPYING PROGRAM OF PREVIOUS
DAY) is pressed will only take effect.
• To continue the change/cancellation, do
not press the PROGRAMMING START
BUTTON until all change/cancellation
are completed.
• The operation controlled by timer is exe-
cuted even while the program is being
set.
Manual operation (Fig. 6)
This schedule timer enables the operation/stop
by pressing the UNIFIED OPERATION/STOP
BUTTON in addition to the operation controlled
by timer (operation/stop according to the pro-
grammed time) at any time.
1.
Press the UNIFIED OPERA-
TION BUTTON, and the OPERA-
TION LAMP turns on.
2.
Press the UNIFIED STOP BUT-
TON, and the OPERATION LAMP is
turned off.
(NOTES)
• The operation automatically stops
according to the programmed time of
system off even during the manual oper-
ation. In the meantime, the operation
starts automatically according to the pro-
grammed time of system start even dur-
ing the stop of operation.
• If the unit is used in conjunction with
other optional controllers for centralized
control, the OPERATION LAMP of the
unit that is not under operation control
may be turned on or off a few minutes
behind schedule. This shows that the
signal is being exchanged, and does not
indicate any failure.
Operation control code
Two different types of operation control codes
can be selected when this kit is used indepen-
dently (when not used in conjunction with the
central remote controller, unified ON/OFF con-
troller, etc.).
Individual
In case where the operation/stop is controlled
by both schedule timer and remote controller.
Centralized
The operation is controlled by the schedule
timer alone, and the operation/stop is controlled
freely with the remote controller during the pro-
grammed time.
(NOTES)
•
For current settings, contact your DAIKIN
dealer.
•
To change settings, contact your DAIKIN
dealer.
Do not change settings yourself.
Error diagnosing function
(Fig. 7)
This schedule timer is provided with the mal-
function diagnosing function. The malfunction
code flashes if there occurs any malfunction in
communication, etc. between and among the
optional controllers for centralized control. In
addition, the operation lamp also flashes if
there occurs any malfunction in communication
with the indoor unit. Check the contents of the
display and contact your DAIKIN dealer
because the signals give you the idea of the
trouble area.
8
Operation lamp
Turn on: The light turns on when any of
the indoor units is in operation
whether the operation is
controlled by timer or by hand.
Turn off: The light turns off when all the
indoor units stop.
01_EN_3P124623-5C.fm Page 9 Wednesday, August 3, 2005 2:20 PM
