Auber Instruments, Inc.
www.auberins.com
JSL-64A-EST Application Guide
Version 1.0 (April 2020)
Introduction
In this document, we will show you the idea of how to use the JSL-64A-EST timer as an espresso-shot-timer on
your home espresso machine. This application guide is based on a home espresso machine that requires 120VAC
power and is installed with a vibration pump also requires 120VAC. If you have an espresso machine and a
vibration pump that require 240VAC, you’ll need to use a relay with 240V coil voltage.
Parts
JSL-64A-EST timer
R30A relay (120VAC coil voltage, and one pair of normally open relay contacts)
Wires, 6 pieces
Wiring
Connect the timer, R30A relay, and the vibration pump as shown in the Figure 1 below. Please note that the red
lines and black lines indicate wires that carry 120VAC, while the blue lines indicates the wires only carry low
voltage signal. Wires attached to pin 1 and 2 on the JSL-64A supply 120V power to the timer. Tap these two wires
to the power button of your espresso machine.
Pump
Mimi Relay
R30A
COM
NC
NO
Original
wires on the
pump
(120VAC)
COM
6
7
8
9
10
1
2
3
4
5
ST
To 120 VAC
A1
A2
JSL-64A Timer
Figure 1. Connecting JSL-64A, relay, and the vibration pump together.
Timer Setting
To use this timer as an espresso shot timer, please set the timer function
FUNC
=
EST
, and the timer unit
T1u
=
S
.
Then press the RST key to clear the screen. The display will show “0.00” as shown in the Figure 2 below. Please
refer to the manual of JSL-64A for details on how access the parameters.
