S
ETTING
W
ELDING
C
ONDITIONS
W
ELDING
C
ONDITION
C
HAPTER
6
6-18
The above-mentioned mode switches in the following order by each pressing the CRATER-FILL key.
"CRATER FILL OFF" - "CRATER FILL ON" - "CRATER FILL ON (REPEATED)" - "Arc Spot".
T I P S
• Even in the Crater-fill off mode, using the internal function (F45) enables to carry out the
welding process in the initial condition before the main welding, and the welding process in
the Crater condition after the main welding. (
sequence (effective/initial standard time setting/crater standard time setting))
6.6.3.1
Crater "OFF"
Select "CRATER OFF" by the CRATER-FILL key.
•
In synchronous to the ON/OFF operation of the torch switch, the welding starts/stops.
Torch switch
Gas flow
Output voltage
Wire feeding speed
Welding current
Main welding
Anti-stick time
ON
OFF
Pre-flow
Post-flow
No-load voltage
Slow-down speed
Welding current
ON
OFF
Содержание WB-M500
