Daihen WB-M500, Руководство пользователя

Страница: 76 / 145

S
ETTING
W
ELDING
C
ONDITIONS
W
ELDING
C
ONDITION
C
HAPTER
6
6-14
6.6 Setting Welding Conditions
This section explains how to set the welding conditions (welding mode or welding parameters).
6.6.1 Welding mode setting
Available combination of the welding mode is listed in the table below. Selecting unavailable
combination displays “- - -“ on the right/left digital meter in a flashing mode.
Standard specification
GAS (*1) WIRE MATERIALS WIRE DIA. (mm) TRAVEL SPEED
Penetration
adjustment
CO
2
MILD STEEL 1.0/1.2/1.6 (*2) (*3) Enable
MILD STEEL CORED 1.2/1.6 STANDARD (*3) Enable
STAINLESS CORED 1.2/1.6 STANDARD (*3) Enable
MAG (20 % CO
2
)
(*1-1)
MILD STEEL 0.8/1.0/1.2/1.6 (*2) (*3) Enable
MILD STEEL CORED 1.2/1.6 STANDARD (*3) Enable
STAINLESS CORED 1.2/1.6 STANDARD (*3) Enable
MAG (10 % CO
2
)
(*1-2)
MILD STEEL 0.8/1.0/ 1.2 (*2) (*3) Enable
MIG (2 % O
2
)
(*1-3)
STAINLESS STEEL 0.8/1.0/1.2/1.6 (*2) (*3) Enable
STAINLESS FERRITE 1.2 (*2) (*3) Enable
MIG (2.5 % CO
2
)
(*1-4)
STAINLESS STEEL 0.8/1.0/1.2/1.6 (*2) (*3) Enable
MIG (100 % Ar)
(*1-5)
Al/PURE 1.2/1.6 (*2) (*3) -
Al/Mg 1.0/1.2/1.6 (*2) (*3) -
Brazing CuSi 0.8/1.0/1.2 (*2) (*3) -
Brazing CuAl 0.8/1.0/1.2 (*2) (*3) -
*1: Note that the "collective" voltage adjustment may not meet the appropriate condition if a mixing gas other than those
with the following mixing ratios is used.
*1-1: MAG gas: Argon (Ar) 80 % + Carbon dioxide (CO
2
)20 %
*1-2: MAG gas: Argon (Ar) 90 % + Carbon dioxide (CO
2
)10 %
*1-3: MIG gas (stainless steel): Argon(Ar) 98 % + Oxygen (O
2
)2 %
*1-4: MIG gas: Argon(Ar)97.5 % + Carbon oxygen (CO
2
)2.5 %
*1-5: MIG gas (Aluminum/Aluminum bronze/Silicon bronze): Argon (Ar)100 %
*2: Available for applications either of "STANDARD" or "HIGH".
*3: For "STANDARD" mode, the standard mode or extended cable mode (extended mode of power cable) is available.
( 6.7.2.1
-
F1: Standard/Extended cable mode)