Daihen OTC Welbee M350L, Руководство пользователя

Страница: 72 / 150

W
ELDING
C
ONDITIONS
W
ELDING
C
ONDITION
C
HAPTER
6
6-8
6.3 Welding Conditions
This section explains basic welding conditions with useful functions.
6.3.1 Basic welding conditions
This section explains the basic welding conditions. To carry out the welding operation, the followings
should be considered:
• Plate thickness and materials of welding material
• Type and flow rate of shield gas
• Wire type and wire diameter, and welding method (type of welding)
• Welding current and welding voltage
21 VOLT.ADJUST key
Sets welding voltage. Switching the mode is enabled by pressing the key.
• When the LED of the VOLT. ADJUST key is on: SYNERGIC mode. (The welding voltage
is automatically set according to the set welding current. To fine-tune welding voltage,
adjust the synergic fine adjustment knob.)
• When the LED of the VOLT. ADJUST key is off: INDIVIDUAL mode. (In the individual
adjustment setting, welding current and welding voltage are adjusted respectively.)
22 WELD MONITOR key
Sets welding control function. (See Chapter 7 Administrator Functions.)
Pressing this key for a second or more lights up the LED, and the sequence transits to the
welding control mode.
23 LOAD key
Reads the registered welding condition from the internal memory. ( 6.5
-
Memory
Function of Welding Conditions)
24 SAVE key
Registers the set welding condition in the internal memory. ( 6.5
-
Memory Function of
Welding Conditions)
25 ENTER key
Carries out the administrative functions such as key lock, password, and registration of
welding condition to the memory.
Depressing the key for three seconds or more makes the LED lit, enabling the key lock
function.
26 WARNING/Temperature LED
Lights up or flashes when any failure or abnormal condition occurs in the welding power
source. (
9.1
-
Action in Case of Error)
27 USB connector
For variety of registered data, writes to or reads from the USB memory. ( Chapter 7
-
Administrator Functions)
28 Terminals for service use Terminals for the OTC service use.
*1: Selective options can be optionally available (OP).
No. Name Function