6-45
Chapter 6
W
elding Condition
S
ETTING
I
NTERNAL
F
UNCTIONS
W
ELDING
C
ONDITION
C
HAPTER
6
6.7.2.37 F53: Sampling speed of data log function
Selects the data sampling interval in using data log function.
The relationship between the setting value and the data sampling is as follows:
For data log function; (
-
Data Backup (Utilization of data)).
6.7.2.38 F54 Tack start process
This function enables to start the wire feeding speed with the normal feeding speed without slow-down
after the welding completion. (which enables the tack welding of less transition time)
•
[ON]: Pressing the torch switch within 0.5 seconds after the welding completion can start it with the
normal feeding speed. (The wire feeding speed at this time is not exceeding 197 IPM (5m/min).)
•
[OFF]: disables the function.
6.7.2.39 F55 to F59: Reserved
Used in connection with the automatic machines of other manufacturers.
6.7.2.40 F67: Setting change of current value (initial condition, crater condition)
When “CRATER ON” is selected, the current value of the initial condition and the crater condition can
be set in percentage based on the current value of the welding condition.
•
[ON]: enables the function.
Set the current value of the initial condition with F68, and set the current value of the crater condition with
F69.
•
[OFF]: disables the function.
6.7.2.41 F68: Setting of current value (initial condition)
The current value of the initial condition can be set in percentage based on the current value of the
welding condition.
•
Setting range of current value (initial condition): 10 % to 300
%
6.7.2.42 F69: Setting of current value (crater condition)
The current value of the crater condition can be set in percentage based on the current value of welding
condition.
•
Setting range of current value (crater condition): 10 % to 300 %
Setting Sampling
interval
1
10 ms
2
100 ms
3
1 s
Содержание OTC Welbee M350L
Страница 2: ......
Страница 8: ...TABLE OF CONTENTS vi MEMO ...
Страница 138: ...TROUBLESHOOTING TROUBLESHOOTING CHAPTER 9 9 6 ...
Страница 150: ...MATERIALS FOR SETTING WELDING CONDITIONS REFERENCE MATERIALS CHAPTER 10 10 12 ...