12
5.1.5 Controls for MIG welding
5.1.5.1 Gas selection: CO2--ordinary CO2 gas; MIX--20% CO2 80% argon; FLUX-- flux cored
5.1.5.2 Function selection: 2T in MIG mode/4T in MIG mode; VRD in MMA mode
5.1.5.3 Welding mode selection: MIG welding mode; TIG welding mode; MMA welding mode
5.1.5.4 Voltage meter: in MIG mode it shows setting voltage and welding voltage; in other modes no voltage
will be showed.
Warning! - Disconnect the power supply when the Alarm light flash.
5.1.5.5 Current meter: in MIG mode it shows wire feed speed,welding current, inductance; in MMA mode it
shows current, hot start current, arc force current.
5.1.5.6 Wire diameter selection: in Synergy mode, select the wire diameter, press the 9 adjustment knob, the
voltage can be adjusted by
±
1V; in Separate mode, welding current and welding voltage can be adjusted
separately--press the button one time to select voltage or current separate adjustment; This button can
not work in MMA or TIG mode.
5.1.5.7 Gas check: gas check function, the button can not work in MMA or TIG mode.
5.1.5.8 Wire check: wire fast feed button--short press this button and
5.1.5.9 Adjustment knob: In MIG mode-- voltage adjustment, inductance adjustment, wire feed speed
adjustment, current adjustment; In MMA mode -- inductance adjustment, hot start current adjustment; In
TIG mode--current adjustment.
5.1.5.10 Mode selection: Hot start function, Arc force function , Inductance selection (Hot start function, the
voltage meter shows HOL; Arc force, the voltage meter shows FO
Г
)
Note:
this MIG welding machine MIG welding can be both synergic and separate, select the wire feed speed
the voltage parameter will be matched automatically.
Please select the wire diameter according to the wire you use.
Voltage refine initialization value is 0, refine the voltage by
±
1V according to different kinds of gas.
In synergy mode, the base gas is CO2, to lower the voltage by 2-3V for mix gas.
Inductance initialization value is 0, adjust range
±
10.
Note:
for flux cored wire, connect the Polar conversion line to Negative (-) Welding Output Terminal, connect
the earth clamp to Positive (+) Welding Output Terminal; For ordinary wire, connect the Polar conversion
line to Positive (+) Welding Output Terminal, connect the earth clamp to Negative (-) Welding Output
Terminal
.
1
2
3
4
5
6
7
8
9
10
Содержание VARMIG 1605D PROFIMIG
Страница 23: ...22 10 CONNECTION DIAGRAM OF THE MACHINE...
