- 54 -
10. OPERATION (continued)
(2) When pressing the ENTER key [19] after setting the condition number, the ENTER lamp
blinks (located at the upper left of the key). Under this condition, you are allowed to confirm
the setting value of the parameter preset to the condition number by using the Parameter
selection key [3]. The setting value of the parameter you selected blinks.
Note:
In the save mode, you can not change the welding condition number or select any
memory/readout mode. To reset the condition number, press the SAVE key [18], then
return to the step (1).
To quit the setting and exit from the memory mode, press the LOAD key [17].
(3) Pressing the ENTER key [19] again holds the data in memory and allow you to exit from
the memory mode.
ԙ
LOAD Function
The welding conditions stored in memory are read out from the memory inside welding power
source.
Note:
The welding conditions currently used are overwritten with the welding conditions
that are read out. When you wan to save the welding conditions that have been used
until now, set the welding conditions to any condition number, then carry out readout.
٨
Reading out the preset welding conditions
(1) When pressing the LOAD key [17], the machine enters the readout mode, LOAD lamp
(located at the upper left of the LOAD key) lights up. See the figure below. The condition
number "1" in the right-side display blinks and the JOB No. LED lamp lights up. In the left-
side display, the setting of welding current preset to condition number "1" lights up. Under
this condition, a condition number can be set while turning the parameter adjusting knob [4].
Welding Current held in memory
Condition blinks
In the event that any memory data is preset to the condition number you selected, the
CRATER lamp, the WELDING METHOD lamp, etc. also lights up. When no memory data
is preset to the condition number, "- - -" in the left-side display appears and blinks. See the
figure below.
(2) When pressing the ENTER key [19] after setting the condition number, the ENTER lamp
(located at the upper left of the key) blinks. Under this condition, you are allowed to confirm
the setting of each parameter you want to read out by using the Parameter selection key
[3]. The setting of the parameter you selected blinks.
WARNING
A
%
JOB
NO.
Se
Hz
WARNING
A
%
JOB
NO.
Se
Hz