- 49 -
10. OPERATION (continued)
(20) 2 stroke slope function: Function No. “24”
When turning on the torch switch, welding current increase from initial current setting. Then after
up-slope time, current becomes main current. When turning off the torch switch, welding current
decrease to crater current setting. After down slope time, the weld is ended.
When turning the function No.24 ON, this function can be used. Then settings are changed
automatically such as crater: ON, initial current: ON, slope: ON. When turning function
No.24 OFF, ordinary sequence can be used. However crater, initial current and slope
condition do not change.
When initial current is OFF, welding starts with main current.
When slope is OFF, this function doesn’t operate.
10.1. 18
Analog remote control (K5416T)
(optional accessory)
When the power switch was turned ON, the analog remote control is automatically recognized.
When the analog remote control is connected to the machine, the only remote control is
effective and the parameters “welding current (base current)” and/or “pulse current” selected
on the front panel may not be adjusted by the parameter adjusting knob [4] on the front panel.
They must be adjusted on the analog remote control that is connected to the machine. Those
set values may be monitored on the digital display on the front panel.
When take off the remote control, setting figure disappear.
* Insert and withdraw the remote control always after turning the power switch “OFF”.