- 42 -
WARNING
A
Se
Hz
%
JOB
NO.
10. OPERATION (continued)
10.1.17
Internal Functions
This welding machine has various special functions that may be used by setting
with F-key (Function selection key) [10].
٨
How to use internal functions
Ԙ
When Function selection key [10] is depressed, the function No. starts blinking on
the left display described below and the status assigned to that function No.
appears on the right display. In this state, the function No. desired may be set
with the parameter adjusting knob [4].
Function No. blinks Status of function appears
↓
It is possible function No. is changed by parameter adjusting knob [4].
̪
The example given above shows that the function [F1] is set to [ON].
ԙ
When Function selection key [10] is depressed while the desired function No.
appears on the display, the function No. will light up while its status indication will
start blinking. In this state, the desired status can be selected with the parameter
adjusting knob [4].
Function No. appears Status of function blinks
↓
It is possible function No. is changed by parameter adjusting knob [4].
The example given above shows that the function [F4] is set to [OFF].
Ԛ
When Function selection key [10] is depressed again, the displays will go back to
the state as shown above in
Ԙ
while the function No. will stop blinking. To exit
this function setting mode, hold Function selection key [10] depressed for a
longer time.
Note:
When the function settings are changed in this mode by selecting with the
parameter adjusting knob [4], they become effective immediately at once (without
asking you to confirm). Therefore it is needed to carefully check, before exiting
this mode, if the status is properly assigned to those functions as desired.
WARNING
A
Se
Hz
%
JOB
NO.
Se
Hz
%