Daewoo KOR-612L0S, Руководство по обслуживанию

Страница: 29 / 55

28
(1) Remove the gasket door (A06) from door painting AS (A04).
(2) Remove the barrier screen inner (A05) from door painting AS (A04).
(3) Remove the door frame (A02) from door painting AS (A04).
(4) Remove the top hinge stopper (A03) from door painting AS (A04).
(5) Remove the spring (A08) and the hook (A07).
(6) Remove the barrier screen outer (A01) from door frame (A02).
(7) Remove the above steps for reassembly.
4. Method to reduce the gap between the door
seal and the oven front surface.
(1) To reduce gap located on part ’A’.
1) Loosen two screws on the top hinge
stopper, and then push the door to con-
tact the door seal to oven front surface.
2) Tighten two screws.
(2) To reduce gap located on part ‘B’.
1) Loosen three screws on under hinge stopper, and then the door to contact the door seal to
oven front surface.
2) Tighten three screws.
(3) To reduce gap located on part ‘C’. (See Fig. A)
1) Loosen a screw on the interlock switch assembly located at the bottom of the oven body.
2) Draw the interlock switch assembly inward as possible to engage with hook on the door bot-
tom.
3) Tighten a screw.
(4) To reduce gap located on part ‘D’. (See Fig. B)
1) Loosen a screw on the interlock switch assembly located at the top of the oven body.
2) Follow step (3) 2) and 3).
NOTE : A small gap may be acceptable if the microwave leakage does not exceed 4mW/cm 2 .
Interlock
monitor
switch