Daewoo DWF-7588TE, Руководство по обслуживанию

Страница: 5 / 34

7 6
AUTOMATIC UNBALANCE ADJUSTMENT
This system is to prevent abnormal vibration during intermittent spin and spin process.
FUNCTIONAL PRINCIPLE
1) Always the safety switch contact is “ON”
position.
2) In case that wash loads get uneven
during spin, the outer tub hits the safety
switch due to the serious vibration, and
the spin process is interrupted.
3) In case that P.C.B. ASS’Y gets “OFF”
signal from the safety switch, spin
process are stopped and rinse process
is started automatically by P.C.B.
ASS’Y.
4) If the safety switch is operated due to
the unbalance of the tub, the program is
stopped and the alarm is given.
CIRCULATING-WATER COURSE AND LINT FILTER
CIRCULATING-WATER
The washing and rinsing effects have
been improved by adopting the water
system in which water in the tub is
circulated in a designed pattern.
When the pulsator rotates during the
washing or rinsing process, the water
below the pulsator vanes creates a water
currents as shown in figure.
The water is then discharged from the
upper part of the tub through the water
channel. About 40 L/min. water is
circulated at the ‘high’ water level,
standard wash load and standard water
currents.
LINT FILTER
Much lint may be obtained according to the kind of
clothes to be washed and some of the lint may also
sticks to the clothes.
To minimize this possibility a lint filter is provided on
the upper part of the tub to filter the wash water as it
is discharged from the water channel. It is good to
use the lint filter during washing.
HOW TO REPLACE LINT FILTER
1) Pull the filter frame upward.
2) Turn the lint filter inside out, and wash the lint off with water.
3) Return the filter as it was, and fix the filter frame to the slot.
RESIDUAL TIME DISPLAY
When the START/HOLD button is pressed, the residual time (min.) is displayed on the time indicator, and
it will be counted down according to process.
When operation is finished, the TIME INDICATOR will light up .
DRAIN MOTOR
STRUCTURE
FUNCTIONAL PRINCIPLE
1) When the DRAIN MOTOR connected to the power source(A.C 220V), the DRAIN MOTOR rotates with
900 r.p.m and revolves the pulley by gear assembly for reducing.
2) When the pulley is rotated, the pulley winds the wire to open the drain valve.
3) Therefore, rotation of pulley changed to the linear moving of wire.
4) The wire pulls the brake lever of Gear Mechanism Ass’y within 5 seconds.
5) After the wire pulled, gear assembly is separated from motor and condition of pulling is held by
operation of the lever.
6) When the power is turned off, the drain valve is closed because the wire returns to original position.
NOTE:
The alarm finished when you close the lid after opening
it. Check the unbalance of the wash load and the
installation condition.
Bleach Inlet
Filter
Pulsator
Contact of safety switch
Contact lever A
Normal (ON)
Position of
unbalanced load
(OFF)
Pull
Loosen
Pulley
Lever
Inductive ring
Magnet
Coil of motor
Magnet of motor
Tub
Filter
Water
channel
Pulsator
Outer tub