23
22
PROBLEM
THE
WASHER
DOES NOT
DRAIN.
CHECK POINT
Do you put down
the drain hose?
Does the drain
motor operate
normally?
Is the input voltage
of drain motor
normal?
CAUSE
SOLUTION
Install drain hose
properly.
Remove the foreign
matter.
Change the drain
motor.
Change the P.C.B
ASS’Y.
Improper installation
Drain problem by the
foreign matter
accumulated inside
drain valve housing.
Drain motor is
defective.
P.C.B ASS’Y is
defective.
CONCERNING DRAINING
YES
NO
NO
NO
YES
YES
CONCERNING WASHING
PROBLEM
WATER
SUPPLY IS
NOT
STOPPED.
CHECK POINT
Does the water supply
continue while the
power is turned off?
Does the water supply
start as soon as you
press the power switch?
Operate the washer
after setting the water
level to “HIGH”
Does the water supply
continue after the
water reaches to the
“HIGH” level?
Is the air tube of water
level switch kinked or
deformed?
CAUSE
SOLUTION
Change the water inlet
valve.
The water inlet valve is
defective.
The triac of P.C.B is
defective.
Change the P.C.B
ASS’Y.
Normal operation.
Change the air tube.
Air tube is defective.
Change the pressure
switch.
Pressure switch is
defective.
PROBLEM
THE
PULSATOR
DOES NOT
ROTATE
EVEN IF THE
WATER IS
SUPPLED.
CHECK POINT
Does the motor operate after
finishing water supply?
Does the motor make
operating sound?
Is the connection
condition of capacitor
terminal good?
Does pulsator rotate
in only one direction?
Is the motor coil
disconnected?
Is the V-belt worn out?
The triac of P.C.B is
defective.
Motor is defective.
Improper connection
V-belt is defective.
Change the P.C.B
ASS’Y.
Normal
Change the motor.
Connect the terminal
properly.
Change the V-belt.
Change the motor.
CAUSE
SOLUTION
YES
YES
YES
NO
NO
YES
YES
NO
YES
YES
YES
NO
NO
NO
NO
NO
NO
NO
Содержание DWF-7588TE
Страница 29: ...53 52 PARTS DIAGRAM...
Страница 33: ...60 CIRCUIT DIAGRAM...
Страница 34: ...63 62 BARE PCB BOTTON BARE PCB TOP...